BMW Diamond Head Key Initilization

• Close all doors.
  
• Turn ignition switch to the Accessory position, and then turn it off again within 5 seconds.
  
• Within 30 seconds of turning the ignition switch to "off".
  
• Press and hold down the unlock button (button with the up arrow marking).
  
• While holding down the unlock button, depress and release the lock button (button with the BMW® logo) three times (within 10 seconds of depressing the unlock button).
  
• Release the unlock button.
  
• The LED in the key will flash momentarily.
  
• The Lock Module will immediately lock and unlock the doors signaling a successful initialization.
  
• Without turning the ignition on again, repeat steps 3 through 5 for additional transmitters (up to four transmitters can be initialized to one receiver).
  
• Switching the ignition to Accessory completes the initialization.

NOTICE: The information contained on this site is presented for information and reference only. Haus of Parts llc dba GermanPartsOnline.com is not responsible for any actions you take on any vehicles. If you have any doubt as to repairs on your vehicle, please contact a qualified technician.

NOTICE: The information contained on this site is presented for information and reference only. Haus of Parts llc dba GermanPartsOnline.com is not responsible for any actions you take on any vehicles. If you have any doubt as to repairs on your vehicle, please contact a qualified technician.

Incorrect information, omissions or errors please report to contact us at GermanPartsOnline.com